|
|
发表于 2013-7-9 22:42:10
|
显示全部楼层
回复 1# wjlyxf2005 ( x+ _# _# w% C. J$ l
2 H V! G: v- L% X$ h! j, f _1 f
' L, x8 { E9 P ^ 打开后处理,查找:
* u; l9 ~. B! w8 A4 r- npfr_l #Format feedrate for lathe y% z0 F& B4 f# L
if opcode = 104,# l+ X% M# f$ W8 E
[
5 a2 |9 i- M6 @' ^ #Format feedrate for lathe thread
; b0 g, B; l0 p4 S4 u; R I result = nwadrs(stre, feed)
; U, i. C) ?1 m1 X& I, J result = newfs (19, feed)
0 i+ p( g' E- J4 ~8 x, x* T4 s ]
K' x5 |! B7 r2 @ else,. O& }# d& M3 w3 O2 e0 r# F
[
3 b0 |: `- [0 z% a0 u( f result = nwadrs(strf, feed)
: Y- k. L1 t7 ?, ]. H" E% l result = newfs (18, feed)
8 c: X/ M* J s% R) g ]
- l, R f" l# _
5 x3 e, l0 J; ]改为:" ]+ V% I! U, A* {3 Y- [$ s$ i
pfr_l #Format feedrate for lathe; D$ x" F# i( ~7 k6 @
if opcode = 104,
5 _. i+ a0 @9 {4 e+ z# a [
3 N6 \6 R$ w0 b$ c e* ^ v' c5 c #Format feedrate for lathe thread
% ]$ U' s. r* r: T; M( l result = nwadrs(strf, feed)
5 |5 }" c7 S O& m result = newfs (18, feed)
% Q4 U; j; A7 z; ~9 j' W8 n! z ]
* @2 A% _3 b2 ?: q& @4 J else,
; c3 C/ R8 ~3 Z9 S [ H s$ K* M; A3 z1 d+ ?
result = nwadrs(strf, feed)/ F1 P( `0 K" l3 B1 t: |- K `
result = newfs (18, feed): f/ t+ z! a$ G' w, u
] |
|