|
|
发表于 2014-3-2 19:58:40
|
显示全部楼层
回复 6# 玄野計
6 o; f6 d: ?( \9 }7 ], O. [1 Q6 Z/ I2 A7 |# k: M
用自带5轴后处理,把摆长写进后处理,长度采用刀具mastercam软件设置长度即可,如下设置即可参数。! b' r9 a) |- P1 b# J6 \: m
刀具长度设置(无RTCP功能使用); @- B; i" k- f
use_tlength : 0 #Use tool length, read from tool overall length
' D# f% R' ^- K7 ? ]9 p) w9 n #0=Use 'toollength' var, 1=Mastercam OAL, 2=Prompt B# l0 |" t9 @2 E" x
9 G6 Z# R4 |0 B& ^' i. h' I% N
摆长设置
& b# b6 Y) d. ^, v* nsaxisx : 0 #The axis offset direction?
7 m* h" O* Y6 n+ [; B2 Hsaxisy : 0 #The axis offset direction?
& U3 e" P$ r; o! M( _saxisz : 310 #The axis offset direction? |
|