|
|
发表于 2014-3-2 19:58:40
|
显示全部楼层
回复 6# 玄野計
8 j& ]* Y6 N5 v
7 g# F9 t/ \5 v$ ~, L( y. ?用自带5轴后处理,把摆长写进后处理,长度采用刀具mastercam软件设置长度即可,如下设置即可参数。
& E# J8 w8 m# F& Y" @! J4 a刀具长度设置(无RTCP功能使用)
+ W' D$ i$ J) \3 e* i# Xuse_tlength : 0 #Use tool length, read from tool overall length
; H) y, p. ]4 U6 @5 Y* n #0=Use 'toollength' var, 1=Mastercam OAL, 2=Prompt4 x8 I+ N. w; s4 L
: L3 x6 W, I5 Y1 h, a1 i8 a摆长设置
2 ]% o! w j6 O) `3 X! psaxisx : 0 #The axis offset direction?
6 U. p* J% ]. ^0 d2 `saxisy : 0 #The axis offset direction?7 V o6 X- H. v+ Y
saxisz : 310 #The axis offset direction? |
|