|
|
发表于 2014-3-2 19:58:40
|
显示全部楼层
回复 6# 玄野計
$ @: b5 P$ g: G d) U. e, v8 s. g' t# }8 `/ h
用自带5轴后处理,把摆长写进后处理,长度采用刀具mastercam软件设置长度即可,如下设置即可参数。& ?3 L; z" B; F& W. |$ \5 m
刀具长度设置(无RTCP功能使用) ~% V. N; v6 E9 o
use_tlength : 0 #Use tool length, read from tool overall length
/ b0 p3 A$ @. s+ W #0=Use 'toollength' var, 1=Mastercam OAL, 2=Prompt
/ |$ ]9 j8 v( {- \2 O$ H) [; b5 ?; w1 J9 R; C7 F2 ^( t
摆长设置
# _# ^3 w1 h% [& x& rsaxisx : 0 #The axis offset direction?* F1 _# A% H* b
saxisy : 0 #The axis offset direction?+ _; m/ Z3 d ^
saxisz : 310 #The axis offset direction? |
|