|
|
发表于 2014-3-2 19:58:40
|
显示全部楼层
回复 6# 玄野計
" s" z5 P5 V, I& e6 f7 {$ n7 |0 G8 [- C% E. D
用自带5轴后处理,把摆长写进后处理,长度采用刀具mastercam软件设置长度即可,如下设置即可参数。
6 E4 W; {: Q( c: M/ `8 W刀具长度设置(无RTCP功能使用): g$ `8 m" h$ o' {4 u
use_tlength : 0 #Use tool length, read from tool overall length
. J" Q. N1 y4 q4 G #0=Use 'toollength' var, 1=Mastercam OAL, 2=Prompt
, n* W* a9 j' C* l0 ~( L6 j' m- D; o* f D: j U* J I
摆长设置8 w8 w/ a+ d9 E( u: j
saxisx : 0 #The axis offset direction?& C' K5 W% Z- H3 r9 ]+ P& \* F
saxisy : 0 #The axis offset direction?9 s' |% @ K7 N* q8 R
saxisz : 310 #The axis offset direction? |
|